My 3D printed plug size progression

Hello! Today i will show you the progression of my 3D printed plugs through the time. There will be a picture of the plug and just below it a description with dimensions and the most important aspect of it.

From the left, the small, to the right, the biggest plug.

Somewhere a year ago i printed a bunch of plugs trying to find the best size and shape to my butt. I found that the narrow shape on the base and a smooth transition between small and larger part was ins fact the best for me. After the first plug, the left one, i bought the B-51 and instantly i found out that it was too big for me. Since then i printed a few more plugs to open my ass to the point i am right now, where i can insert the B-51 in a few minutes.

Here we go with the details of each plug. Every size is given in circumference and centimeters.

The smaller, and the best for extreme long term wearing. The small size is perfect to wear it all the time i want without any discomfort. Even with that possibility i don´t remember the last time i used it. As you can see, i found more pleasure as larger the plug. The sizes are 22.8 at the largest part and 16.5 at the smallest.

Here we have my daily driver. It´s the natural progression from the last plug, and i can wear it for a few hours, even a full day. After that it becomes a little uncomfortable, but i can wear it a full week doing a half day on, half day off. Sleeping with it is really enjoyable. The sizes are 24.5 at largest part and 18.8 at smallest.

This is a special plug for me. When i want to train my outer sphincter but i don´t want to have a lot of discomfort i choose this one. The largest part is the same dimension as the last one, 24.5, but the smallest part is 21.8. As you will see, this is the plug with the largest neck i have. It is even larger than the B-51. A thong is needed to hold it in place if i want to walk with it, or even sleep.

The next daily driver, i hope. The next level from my actual favorite plug. It have the largest head of all my plugs, but right now is pretty difficult to hold it inside for more than two hours. I need to train my insides more often to take it for a long term. The sizes are 25.7 and 19.8.

I said that i can insert it with a few attempts, and it is not even the largest plug i have. But there is something with it that i can not tell... the weight... the shape... i don´t know, but is really hard to keep it in. Maybe the silicone makes it really hard to remove once the lubricant is absorbed because it hurt a little bit compared to the 3D printed plugs.

Witch one i am using right now? My favorite plug of course! Feel free to leave a comment. Bye!